Installation Sheet

1. Carefully remove all parts from the box.
2. Thread the finial (E) to the top of the fixture body (D).
3. Open the front door of the fixture body, place glass panels (F) on the side of the frame
and secure it by bending the metal tabs.
4. Place glass panel (G) on the door of the frame and secure it by bending the metal tabs.
5. Insert bulbs (not included) into the sockets, then close the door.
6. Connect ground wire from the fixture (bare copper) to the ground wire from the outlet box
(usually green or copper in color) using wire nut (B).
IT IS IMPERATIVE THAT THIS FIXTURE BE GROUNDED.
7. Connect the fixture Neutral wire (WHITE) with the neutral wire (White) from the outlet box
using wire nut (B).
8. Connect the fixture Hot wire (BLACK) with the hot wire (Black) from the outlet box using
wire nut (B).
9. Tuck wire connections neatly into post cup.
10. Put the lantern onto the post (A).
11. Use provided screws (C) to fix the lantern on the post.
12. Installation is complete, turn on power at fuse or circuit breaker.
***Clean with a dry, soft cloth only. Use no harsh abrasives or chemical agents.
Albermarle Post Light
Item # CHO 7414
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING***SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY
DAMAGE OR OBVIOUS DEFECT. DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
NOTE: CAREFULLY UNPACK EACH PIECE IN TOP LAYER OF PACKING PRIOR TO
REMOVING. RETAIN ALL PACKING MATERIAL UNTIL INSPECTION AND
INSTALLATION ARE FINAL.
WET
L
I
S
T
E
D
C
US
Intertek
CM
DO NOT INSTALL ON POST OR POLE THAT RESULTS IN
A VERTICAL RISE OF 25 FEET OR HIGHER.