Installation Sheet

ASSEMBLY INSTRUCTIONS

WE RECOMMMEND INSTLLATION OF THIS LIGHTING FIXTURE BE DNE BY A

LICENSED ELECTRICIAN.

WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN

FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.

INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS

ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.

ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.

1. Open the door (G) by loosen locking pins (H).

2. To install glass panel (K) provided to front frame (G), make sure metal tabs

(F) are ﬂipped against the opening of the frame. Place glass panel (K) to front

frame, secure glass panel (K) by bending back metal tabs (F) towards the glass

panel. To install rest four glass panels (J) into side frames and secure with the

metal tabs on the frame.

3. Attach the top hook on the candelabra assembly (I) to the loop (E).

4. Remove back plate (A) from lantern base (D) by removing base screws (C)

and set aside.

5. Connect the hot wire from the ﬁxture (with words on surface) to the hot junction

box wire from the outlet box (usually BLACK). Fasten them together with a

plastic wire connector provided and wrap connection with electrical tape.

6. Repeat this procedure for the neutral wire from the light ﬁxture (without words

on surface) to the wire from the outlet box (usually WHITE).

7. Connect the ground wire from the light ﬁxture (bare copper) to the ground wire

from the outlet box.

8. Attach back plate (A) to ceiling outlet box and tighten with back plate screws (B).

9. Attach lantern base (D) to afﬁxed back plate (A) and tighten with base screws

(C). II. Insert light bulbs (not included) into sockets.

10. Close the door (G) by inserting locking pins (H).

Club Small Square Flush Mount

Item # CHO4310

DAM P

PAGE 1
ASSEMBLY INSTRUCTIONS Club Small Square Flush Mount Item # CHO4310 WE RECOMMMEND INSTLLATION OF THIS LIGHTING FIXTURE BE DNE BY A LICENSED ELECTRICIAN. WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION. INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL. ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED. 1. Open the door (G) by loosen locking pins (H). 2.
PAGE 2
ASSEMBLY INSTRUCTIONS Club Small Square Flush Mount Item # CHO4310 WE RECOMMMEND INSTLLATION OF THIS LIGHTING FIXTURE BE DNE BY A LICENSED ELECTRICIAN. WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION. INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL. ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED. INSTRUCTIONS FOR MOUNTING FIXTURE OUTDOORS AND/OR IN WET LOCATION: 1.