Installation Sheet

1. Carefully remove all parts from the box. Place on a clean, soft surface.

2. Remove mounting plate (B) from fixture by removing screws (D).

3. Install mounting plate (B) to the junction box and secure with

mounting screws (C).

4. Connect the safety cable as shown in diagram.

5. Wrap fixture ground wire (bare copper) around the green grounding

screw (see diagram 1). Tighten. Continue fixture ground wire and

connect to supply ground wire (usually green or bare copper) using

wire nut (A).

NOTE: It is imperative that the fixture is grounded.

6. Connect fixture neutral wire (white) to the supply neutral wire

(usually white) using wire nut (A).

7. Connect fixture hot wire (black) to the supply hot wire (usually

black) using wire nut (A).

CAUTION: Do not reverse the hot and neutral connections.

8. Make sure all wire connections are tight, then carefully tuck into the

junction box.

9. Install fixture to mounting plate (B) by securing with screws (D).

Care Instructions: Clean only with a soft dry cloth or feather duster.

Do not use abrasive or chemical agents.

Gracie Triple Sconce

Item # CHD 2483

ASSEMBLY INSTRUCTIONS

This light fixture should be installed in accordance with all applicable,

local installation codes, and by a person familiar with the construction

and operation of it, as well as the hazards involved. Inspect item and

contents carefully. If any damage or defect is found, do not install.

Retain all packaging material until installation is complete and approved.

TOOLS REQUIRED (NOT INCLUDED):

Phillips Screwdriver

Slotted Screwdriver

NOTICE:

Diagram 1

DAMP

Safety cable

Cable lock nut

1. Wrap the safety cable into the slot hole on the

mounting plate (B).

2. Wrap the safety cable around the cable lock nut.

3. Insert screws into both holes on cable lock nut,

secure screws with screwdriver.