Installation Sheet

ASSEMBLY INSTRUCTIONS

WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A

LICENSED ELECTRICIAN.

WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN

FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.

INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS

ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.

ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.

1. Follow Fig.1 and Fig. 2 to connect the safety steel cable from the ﬁxture and

the safety cable from ceiling with lock nuts.

2. Assembly the ceiling loop, nipple, nuts and hickey to center 1/4”IPS support

pipe and adjust overall length to allow the canopy ﬂush to the ceiling. When the

adjustments have been completed, secure the three (3) nuts, as shown Fig.3.

3. Raise the ﬁxture and make the nipple through canopy (I). then secure with

cap(A) thread the ﬁnial(B) onto the bottom of ﬁxture, and secure with nut.

4. Connect the Ground (bare) ﬁxture wire with the ground (usually bare) wire from

your ceiling box using a plastic wire connect nuts, and the connection to be

wrapped with electrical tape. Be sure no wire strands are exposed. If you house

does not have ground wire, then attach this wire to the green grounding screw

inside of outlet box.

IT IS IMPERATIVE THAT THE J-BOX IN YOUR HOME BE PROPERLY

GROUNDED.

5. Connect the Neutral (ribbed edge, no markings, or white) ﬁxture wire with

the Neutral (usually white) wire from your ceiling box using a plastic wire

connector. And the connection to be wrapped with electrical tape. No wire

strands are exposed.

6. Connect the Hot (smooth edge, markings, or black) ﬁxture wire with the Hot

(usually black) wire from your outlet box using a plastic wire connector. And the

connection to be wrapped with electrical tape. No wire strands are exposed.

DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS, OR SAFETY

WILL BE COMPROMISED.

7. Tuck these wire connections neatly into the outlet box.

8. Insert light bulbs (C) (not included) into sockets.

DRY

Charles Pendant

Item # AH5002

TO assemble safety cables:

1.Join fixture safety cables with cafety

cable from ceiling.

2.Wrap both safety cable around the

cable lock mut.

3.Insert screws into both holes on cable

lock nut,secure screws with screwdrive.

4.Push the cable lock nut into outlet box.

PAGE 1
Charles Pendant Item # AH5002 ASSEMBLY INSTRUCTIONS WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A LICENSED ELECTRICIAN. WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION. INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL. ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED. 1. TO assemble safety cables: 1.Join fixture safety cables with cafety cable from ceiling. 2.