Installation Sheet

ASSEMBLY INSTRUCTIONS
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS
ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
1. Remove mounting plate (C) from fixture base (G) by unscrewing ball nuts (I).
2. Affix mounting plate (C) onto ceiling outlet box (A) and secure with mounting
screws (E).
3. Connect the hot wire from the fixture (BLACK) to the hot wire from ceiling
outlet box (A) (usually BLACK). Fasten together with a plastic wire connector
(B) provided and wrap connection with electrical tape.
4. Repeat this procedure for the WHITE neutral wire from the light fixture to the
wire from ceiling outlet box (A) (usually WHITE).
5. Connect ground wire from the light fixture (GREEN or bare copper) to ground
wire from ceiling outlet box (A) (usually green or copper in color).
6. Attach fixture base (G) to affixed mounting plate (C), letting rods (D) on
mounting plate (C) pass through the holes on fixture base (G), and secure with
ball nuts (I).
7. Insert light bulbs (not included) into sockets (F). To avoid the risk of fire, do not
exceed the recommended wattage.
8. Attach glass diffuser (J) to fixture base (G), letting rod (H) pass through the
center hole of diffuser (J) and secure with nut (K).
9. Restore power to outlet box and test fixture.
10. Installation is complete.
DAM P
Rachel Small Flush Mount
Item # AH4029
AH4029
ASSEMBLY & INSTALLATION GUIDE
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A LICENSED ELECTRICIAN.
WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT
BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR
OBVIOUS DEFECT, DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
1. Remove mounting plate (C) from fixture base (G) by unscrewing ball nuts (I).
2. Affix mounting plate (C) onto ceiling outlet box (A) and secure with mounting screws (E).
3. Connect the hot wire from the fixture (BLACK) to the hot wire from ceiling outlet box (A) (usually BLACK). Fasten
together with a plastic wire connector (B) provided and wrap connection with electrical tape.
4. Repeat this procedure for the WHITE neutral wire from the light fixture to the wire from ceiling outlet box (A) (usually
WHITE).
5. Connect ground wire from the light fixture (GREEN or bare copper) to ground wire from ceiling outlet box (A)
(usually green or copper in color).
6. Attach fixture base (G) to affixed mounting plate (C), letting rods (D) on mounting plate (C) pass through the holes on
fixture base (G), and secure with ball nuts (I).
7. Insert light bulbs (not included) into sockets (F). To avoid the risk of fire, do not exceed the recommended wattage.
8. Attach glass diffuser (J) to fixture base (G), letting rod (H) pass through the center hole of diffuser (J) and secure
with nut (K).
9. Restore power to outlet box and test fixture.
10. Installation is complete.
(G)
(H)
(J)