Installation Sheet

ASSEMBLY INSTRUCTIONS

WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A

LICENSED ELECTRICIAN.

WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN

FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.

INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS

ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.

ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.

1. Attach ground (green) wire to ground wire from wall outlet box (usually green

or copper in color), fasten together with a plastic wire connector. Tightly wrap

the wire connector with electrical tape so the end of the connector is sealed.

IT IS IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME BE

PROPERLY GROUNDED.

2. Connect neutral (white) ﬁxture wire coming from ﬁxture base to neutral (usually

white) outlet wire. Fasten both wires together with a plastic wire connector and

tightly wrap the wire connector with electrical tape.

3. Repeat the procedure with the hot (black) wires. Always make sure that no

wire strands are left outside the connectors.

DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OR SAFETY

WILL BE COMPROMISED.

4. Remove mounting plate (A) from ﬁxture base (D) by unscrewing base

screws (C).

5. Attach mounting plate (A) to wall outlet box and secure with mounting

screws (B).

6. Attach ﬁxture base (D) onto the afﬁxed mounting plate (A) and secure with

base screws (C).

7. Attach glass shade (F) over the threaded section of socket (E), screw washer

(G) and socket ring (H) onto socket (E) to secure glass shade to socket.

Tighten with fork (J) provided.

8. Insert light bulb into socket.

DRY

Ava Triple Sconce

Item # AH2202