Installation Sheet

ASSEMBLY INSTRUCTIONS
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS
ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
1. Remove back plate (B) from the fixture base (D) by unscrewing base screws
(E) in counter-clockwise direction.
2. Hold back plate (B) at desired location on wall. Mark center points for two
hang holes with a pencil. Remove back plate (B).
3. Drill small holes on each point location on the wall, each hole should be large
enough to accommodate the plastic anchors (A). Push plastic anchors into
the holes in the wall.
4. Affix back plate (B) to wall by aligning holes in back plate (B) with plastic
anchors (A). Install screws (C) into plastic anchors to secure back plate to wall.
5. Attach fixture base (D) to affixed back plate by tightening base screws (E).
6. Remove plastic bushing inside of threaded hole at bottom of fixture base (D).
7. Attach cord cover (F) to bottom of fixture base (D) by turning (F) in
counterclockwise direction.
8. Attach cord cover (G) to bottom of (F) by turning (G) in counter-clockwise
direction.
9. Insert harp (I) into harp saddle (H) by squeezing both sides of the harp.
10. Remove finial (J) from harp (1). Place lamp shade (not included) over the bolt
attached on top of harp (I), screw finial (J) onto the bolt to secure lamp shade
to the harp.
11. Insert light bulb into socket.
12. Remove protective plastic (L) from electrical plug (K).
13. Plug lamp into wall outlet box.
DRY
Gene Swing Arm
Item # AH2012