Service manual

6: Mechanical and Electronic Adjustments
CHRISTIECHRISTIE 35/70 Service/PM Manual
March, 1997
Line Voltage Selection
To locate jumpers and terminals, refer to the 35/70 Power Supply component layout in Section 8.4.
240-VAC Operation
To configure the 35/70 projector for 240-VAC operation:
1. Remove the jumper from terminals 1&3 and 2&4 on T1 and the jumper T1 terminals 2&3.
120-VAC Operation
To configure the 35/70 projector for 120-VAC operation:
1. Remove the jumper from terminals 2&3 on T1 and jumper terminals 1&3 and 2&4 on T1.