Service manual

3: Operating the Projector
CHRISTIE INC. CHRISTIE INC. - - 35/70 Service/PM Manual
July, 1997
8. At the end of the show a CLOSE DOUSER (<C4>) command must be sent to the projector to close the douser and a
STOP (<K0>) command must be sent to the Master Motion Controller to stop the projector.
9. From this point the projector must be taken out of interlock, with the LOCAL MODE (<HE>) command, and
rewound to the start of the show by entering a CUE NEXT (<H7>) command into the projector.
10. Repeat steps 2 to 9 to play the next show.
Power Down Sequence
To turn off power to the projector, enter the following command key sequence:
(<G>,<9>) : Re-activate the projector keypad.
<STOP> : Stop the projector if it is in motion.
<NOT RDY> : Remove power from projector motors.
Power to the projector, lamphouse, and show controller may then be removed in any order.