Service manual

3: Operating the Projector

CHRISTIE INC. CHRISTIE INC. - - 35/70 Service/PM Manual

July, 1997

G6: The OUTPUT CUE TAPES Command [DX]

This diagnostic command downloads the position of each BOF and EOF cue tape, as it has been loaded into the projector,

to the show controller. The output data is in the format shown in Table 2.8.

ENTRY:

<CMD-G>, <6>

CODE:

ACTION

1.Outputs PROMPT followed by BOF for first show.

2.Outputs successive BOF and EOF positions, each preceded by

a PROMPT.

STATUS:

Unchanged.

Output Meaning

<CR> <LF> *

hh:mm:ss:ff <PROMPT> BOF for Show #1

hh:mm:ss:ff <PROMPT> EOF for Show #1

hh:mm:ss:ff <PROMPT> BOF for Show #2

hh:mm:ss:ff <PROMPT> EOF for Show #2

. . .

repeated for

additional shows

Table 2.8: OUTPUT CUE TAPES Data Format.

G7: The SHUTTER TEST Command [DX]

This diagnostic command is used to test the speed of the shutter. LED 0 on the control keypad is used as an indicator of

this test’s success or failure.

ENTRY:

<CMD-G>, <7>

CODE:

G7 (also HD, from remote interface only)

ACTION

LED 0 flashes and remains OFF if shutter speed is correct.

LED 0 flashes and remains ON if shutter speed is incorrect.

STATUS:

Unchanged.