Service manual

3: Operating the Projector
CHRISTIE INC. CHRISTIE INC. - - 35/70 Service/PM Manual
July, 1997
G3: The AUTO DOUSER Command [OP]
This operational command enables the projector to automatically open the douser 3 seconds into the film after the
projector has been commanded to run FORWARD. This function is reset when the projector goes into a NOT READY
condition.
ENTRY:
<G> , <3>
CODE:
G3
ACTION
S:
Allows the douser to be automatically opened 3 seconds into the
film.
STATUS:
Unchanged.
G4: The LOAD REEL COUNTER Command [DX]
This diagnostic command loads the time code value of the frame counter register into the reel counter register. This
command is used for motion programming, and is not a part of normal operation.
ENTRY:
<G> , <4>
CODE:
G4
ACTION
S:
Sets the reel counter equal to the frame counter.
STATUS:
Unchanged.
G5: The SET PLATTER MODE Commands [OP]
This operational command sets the projector to platter mode. This command is recognized only in the NOT READY state.
ENTRY:
<CMD-G>, <5>
CODE:
G5
ACTION
S:
Disables upper and lower torque arm operation. Enter a NOT
READY command to reset projector to the default reel mode.
STATUS:
Unchanged.