Service manual

3: Operating the Projector
CHRISTIE INC. CHRISTIE INC. - - 35/70 Service/PM Manual
July, 1997
G2: The SELECT FRAME RATES Commands [DX]
This diagnostic command allows entry of the selected frame rate and the number of perfs per frame. Default values are 30
fps and 5 perforations unless specified otherwise. When using 35mm film select 5 perforations.
ENTRY:
<CMD-G>, <2>
CODE:
G2
INPUT:
1. Select the frame rate:
• Enter a 2 from the keypad to select 24 frames per second
• Enter a 5 from the keypad to select 25 frames per second
• Enter a 3 from the keypad to select 30 frames per second
• Enter a 4 from the keypad to select 48 frames per second
• Enter a 6 from the keypad to select 60 frames per second.
2.Select the number of film perfs:
• Enter a 5 from the keypad to select 5 perfs.
• For models equipped with 8-perf capabilities, enter an 8
from the keypad to select 8 perfs.
ACTION
S:
1.Reset frame rate and number of perfs.
2.Display frame rate in the second- and third-last positions on
the LED display, as shown in Figure 2.3.
3.Display number of perfs in the last position on the LED
display, as shown in Figure 2.3.
STATUS:
Unchanged.
5 perfs30 fps
SEC
FRS
MIN
HRS
Figure 2.3: SELECT FRAME RATES LED Display