Service manual

3: Operating the Projector
CHRISTIE INC. CHRISTIE INC. - - 35/70 Service/PM Manual
July, 1997
ENTRY:
<H> , <D>
CODE:
HD
INPUT: Number of shows on reel (must be from 1 – 6).
ACTION
S:
Sets maximum number of shows on the current reel of film.
STATUS:
Unchanged.
HE: The LOCAL MODE Command [DX]
This diagnostic command takes the projector out of interlock mode. Interlock mode allows the projector to be
interlocked, via BI-Phase, to an external motion source or MASTER projector.
To prevent film damage, enter this command only when the external motion source is
idle.
ENTRY:
<LOCAL>
CODE:
HE
ACTION
S:
Take the projector out of interlock mode.
STATUS:
Unchanged.
HF: The DISPLAY START Command [DX]
This diagnostic command displays the GOTO frame that was programmed using the SET GOTO command (see Section
0).
ENTRY:
<H> , <F>
CODE:
HF
ACTION
S:
Displays the GOTO frame in the standard counter format of
hh:mm:ss:ff (see Section 0).
STATUS:
Unchanged.