Service manual

3: Operating the Projector
CHRISTIE INC. CHRISTIE INC. - - 35/70 Service/PM Manual
July, 1997
H1: The PLAY CURRENT SHOW Command [OP,L]
This operational command causes the system to play the current show. The command should be issued from a cue point.
Use this command instead of the FORWARD command to operate projectors configured for MASTER/SLAVE
operation.
ENTRY:
<CMD-H>, <1>
CODE:
H1
ACTION
S:
1.Play current show.
2.Stop at tail of show.
3.Wait for SET NEXT SHOW command (see Section 0).
STATUS: Set to 1 while moving to first frame.
Set to 3 while playing (douser open).
Set to 0 when stopped at end of show.
H2: The SET GOTO Command [DX]
This diagnostic command allows the user to enter a goto point for a subsequent GOTO action. The goto point must be a
frame counter value in the current show. This command is used for motion programming, and is not a normal part of
system operations.
ENTRY:
<CMD-H>, <2>
CODE:
H2
INPUT:
1.Enter the desired goto point with the numeric portion of the
keypad. This is entered in the counter format hh:mm:ss:ff
(see Section 0).
2.Hit the <ENTER> key.
ACTION
S:
Load the goto point value.
STATUS:
Unchanged.