Service manual

2. General Description
CHRISTIE INC. - 35/70 Service/PM Manual
July, 1997
Input Result
1 CD1 Specify Show Cowboy-1
2 01 00 00 00 BOF time for Cowboy-1
3 <ENTER> Accept displayed value
4 01 04 43 16 EOF time for Cowboy-1
5 <ENTER> Accept displayed value
6 01 05 00 00 BOF time for Cowboy-2
7 <ENTER> Accept displayed value
8 01 09 17 10 EOF time for Cowboy-2
9 <ENTER> Accept displayed value
10 01 09 21 26 BOF time for Desert
11 <ENTER> Accept displayed value
Input Result
12 01 13 55 09 EOF time for Desert
(Incorrect!)
13 <CLEAR> Reject incorrect value
14
01 13 55 08 Correct EOF time for
Desert
15 <ENTER> Accept corrected value
16 01 14 00 22 BOF time for Cactus
17 <ENTER> Accept displayed value
18 01 16 34 00 EOF time for Cactus
19 <ENTER> Accept displayed value
20 <CLEAR> Signify end of film and exit
command sequence; display
shows current film position.
Table 2.6: Sample Command Sequence for Manual Logging
The MANUAL LOG command can also be used to display and check the show lengths that have been entered. Enter the
<C> <D> command, followed by a 1 to indicate Show #1; then press <ENTER> to step through the entire set of BOF and
EOF reel times. BOF and EOF values are not changed.
CD: The SHOW CONTROLLER LOG Command [DX]
The function of this diagnostic command is the same as the MANUAL LOG command, except that it is issued through
the serial port via a show controller. The format of the SHOW CONTROLLER LOG command from the show
controller differs from keypad operation in that the CLEAR command is replaced with a hex 3A (or the ASCII symbol
“:”), and the ENTER command is replaced with a hex 3B (or the ASCII symbol “;”). Also, leading zeroes may be
omitted when data is entered from the show controller.
The entry from a show controller over the serial port for the example shown in Figure 2.2 and Table 2.6 would be:
CD11010000;1044316;1020000;1025000;1030000;1035000:
CE: The SET REEL COUNTER Command [DX]
This diagnostic command allows the user to manually change the value of the reel counter.
ENTRY:
<C> , <E>
CODE:
CE
INPUT:
Desired reel counter value in the counter format hh:mm:ss:ff
(see Section 0).
ACTION
S:
Sets the reel counter to the new value.
STATUS:
Unchanged.