Service manual

2. General Description
CHRISTIE INC. - 35/70 Service/PM Manual
July, 1997
ENTRY:
<CMD-C>, <9>
CODE:
C9
ACTION
S:
Reset the frame counter.
STATUS:
Unchanged.
CA: The READY Command [OP]
This operational command initiates the READY sequence.
When the projector is in READY mode, if the <READY> key is pressed again, the LED
display strip displays the reel counter. To return the show counter to the display, enter
a G1 (DISPLAY COUNTER) command.
ENTRY:
<READY>
CODE:
CA
ACTION
S:
1.Apply power to motor systems.
2.Check all limit switches.
3.Check the CV, Pulldown, and Shutter motor systems.
4.Set loop.
5.Execute single frame advance and stop.
STATUS: Set to 0.
CB: The NOT READY Command [OP]
This operational command places the system in a NOT READY state. When in this state, the projector will not
accept any commands that require film motion.
ENTRY:
<NOT RDY>
CODE:
CB
ACTION
S:
1.Remove power from motor systems.
2.Reinitialize software values and turns the AUTO DOUSER
command off .
3.Reset LED error indicators.
STATUS: Set to B.