Service manual

2. General Description
CHRISTIE INC. - 35/70 Service/PM Manual
July, 1997
Table 2.3: Keypad LED Indicators
Keypad LED Indication
0
The CPU detected an error in the shutter speed.
1
The Lower Torque arm activated the limit switch.
2
The Upper Torque arm activated the limit switch.
3
The CPU detected that there is no film in the gate or there
was a pulldown malfunction.
4
The Lower Buckle arm is out of position.
5
The Upper Buckle arm is out of position.
6
The CPU detected a constant velocity fault.
7
There is BOF sensor tape in the gate.
8
There is EOF sensor tape in the gate.
9
Keypad control is enabled.
CLEAR
AUTO
The projector is in the CYCLE TEST mode.
G The projector is receiving or performing one of the G
function commands.
H The projector is receiving or performing one of the H
function commands.
C The projector is receiving or performing one of the C
function commands.
FOR
The projector is running forward.
STOP
The projector is stopped.
REV
The projector is running in reverse.
INTERLOCK
The projector is in INTERLOCK mode.
LOCAL
The projector is in the LOCAL mode.
SET LOOP
The projector is performing a loop set function.
READY
The projector is in READY mode.
CUE
The projector is performing a CUE function.
NOT RDY
The projector is in the NOT READY mode.