User manual

UM0036 Your STVD graphical environment
Doc ID 7705 Rev 11 57/385
The tabs located at the bottom of the Output window area are used to flip through the
different views available in the window. These tabs include:
● Build tab and Tools tab
● Find in Files 1 & Find in Files 2 tabs
● Debug tab
● Console tab
If you right-click the mouse in the Output window tabs a contextual menu appears specific to
that tab. For example, the contextual menu for the Build and Tools tabs is shown in
Figure 37.
Figure 37. Output window contextual menu
Note: Depending on the tab view you are in, the contextual menu may have fewer or different
options than the one shown above.
3.6.1 Build tab and Tools tab
These tabs display information on the current build or tools session.
For example, the view of the Build tab in Figure 38 shows the messages resulting during
build session using the Cosmic toolset. Errors are shown in bold text, and refer to the
source file and line number where the error was found.
Figure 38. Output window Build tab
The contextual menu for the Build and Tools tabs has options that make it easier to jump to
any errors found during the build.
In the Tools tab contextual menu, first choose the parser that corresponds to your toolset.
The various parsers installed appear when Parser Error Selection is selected. A
checkmark appears beside the active parser. Figure 39 shows that the ST Assembler Linker
parser has been activated.