User manual

UM0036 STM8 C tutorial
Doc ID 7705 Rev 11 341/385
Note that STVD automatically fills in the Additional include directories when you add
files to your project.
2. Use the button on the right to browse <st_toolset>/include.
Note that the change only applies to the current build configuration (Debug in this
case). When you make these changes do not forget to repeat them for all build
configurations. Select Release build configuration and repeat the operation.
Caution: TRAP: The user defined paths come after the toolset paths in the general command line.
Before adding any include files, ensure they do not already exist at toolset level. If they do,
you may either change the filename, modify the toolset paths as explained in Section 12.1.1
(impacting all projects), or modify the toolset path only for the project (Project specific
toolset path in General tab of Project Settings).
Figure 269. C compiler options for Raisonance