User manual

Program UM0036
328/385 Doc ID 7705 Rev 11
Unlock device
The Unlock Device option is only available for specific Flash devices. If you check this
option, the programmer will unlock the microcontroller before starting any other
programming activities (such as Erase, Blank check, Program, Verify).
11.2 Assigning files to memory areas
When you program your microcontroller, only the memory areas that you select are
programmed. All areas, except those dedicated to option bytes, are selected for
programming by associating them with one, or more files. Files contain the values to be
programmed to a memory area.
With the Programmer window open (Tools>Programmer), select the Memory Areas tab.
In this tab you can associate the files with your microcontroller’s memory areas for
programming (Figure 259).
Figure 259. Programmer, memory areas view
The memory areas that are available may vary according to the target microcontroller that
you specified when you built your application.
To assign a file for programming to a memory area: