User manual

UM0036 Program
Doc ID 7705 Rev 11 325/385
11 Program
Once you have finished debugging your application and have built the final version, you can
program it to your target microcontroller using STVD’s Programmer.
This feature is based on ST Visual Programmer (STVP). It offers basic programming
features and allows you to program your target microcontroller using a programming board
or in-circuit programming (ICP) hardware.
To access the Programmer, select Tools > Programmer from the main menu bar. The
Programmer window opens.
The following sections provide information about this programming interface, including:
● Section 11.1: Configuring general programming settings
● Section 11.2: Assigning files to memory areas
● Section 11.3: Configuring option byte settings
● Section 11.4: Starting the programming sequence
11.1 Configuring general programming settings
When you access the Programmer (Tools>Programmer), the window opens to the
Settings tab (Figure 258). In this tab you can configure the general settings for
programming your microcontroller.
Figure 258. Programmer settings view
The options in the list boxes will vary according to the target MCU that you identified for your
project when you built your application (for more information, refer to the section about the
Selecting your MCU of the Project Settings window). When programming your MCU, the
target microcontroller is displayed in the Target Device field of the Settings tab.