User manual

EMU3 emulator features UM0036
320/385 Doc ID 7705 Rev 11
Figure 253. Performance Analysis dialog box
In this dialog box, you must specify the following:
● Disable breakpoints: this checkbox disables all current breakpoints during the test.
● Number of passes: the number of times that the specified sequence of code will be
run for the test.
● Starting address: specifies the start address of the sample and the name of the
module in which it is located. The start address may be specified as a bookmark
location in a specific file, or an address. If any Bookmark, Line, or Address field is
completed, the remaining fields are specified automatically.
– Bookmark: current bookmarks are listed in the Bookmark pull-down menu and
may be selected to define the start point for the program sample (click on a
bookmark definition to set it as the start address).
– File: project executable files are listed in this pull-down menu, or may be entered
by hand.
– Line: the line number may be entered here.
– Address: the address may be entered in decimal or hexadecimal format.
● Ending address: as for the Starting address (above), but specifying the final address
of the program section to be tested.
10.6.2 Using the Run/Stop/Continue commands
When the definition is complete, use the Run, Stop and Continue buttons at the top right of
the window to execute/stop the program:
● Run: runs the executable. This command carries out a chip reset and runs the program
from the reset vector.
● Continue: restarts the program from the current Program Counter location. When this
command is used, the performance analysis is also restarted. The elapsed time and