User manual

EMU3 emulator features UM0036
308/385 Doc ID 7705 Rev 11
Figure 243. Programming memory access with data
4. In the Level 1 tab, click Then and set the defined action as a breakpoint, as shown in
Figure 244. Note the program is summarized in the Configuration Summary window
on the left.
Figure 244. Configuration summary of program
Example 3—Break on Condition after function call
In the example below, a breakpoint must be set on a Read within a given block of memory
but the break should not take place until after a specified function is called. Use is made of
the starting address of the function. An opcode fetch at that address indicates the opening
of the function.
Program the Advanced Breakpoints window as summarized in Ta ble 7 5.