User manual

EMU3 emulator features UM0036
300/385 Doc ID 7705 Rev 11
Figure 232. Opcode Fetch with Data dialog box
Note: When Any Memory Access or Opcode Fetch is selected as the type of access, then any
number of access events may be included in the list for that event. If Opcode Fetch with
Data or Memory Access with Data are selected as the type of Memory Access, then only a
single entry is allowed in the list for that event. (This limitation applies only to the current
event, and not between different events in the same or different Levels.)
10.2.3 Other types of events
Other events can be selected in the lower half of the event definition area in each Event
window. Each event type has a tristate checkbox, which allows you to choose between
particular states or signal values, and ignoring the signals.
Figure 233. Other events
● Trace Full: Values True, False or Ignored may be selected.
● Trigger In: Values 1, 0, or Ignored may be selected.
● Analyzer Input: Signals from the Analyzer Input connector (located on the EMU3
Probe) can be used as conditions (for more information, see Section 10.5 on page
317). A single value, a range of values, or selected bits may be defined. An example