User manual

Getting started with STVD UM0036
30/385 Doc ID 7705 Rev 11
2.5 Select and connect to your debug instrument
STVD allows you to debug your application using the Simulator (software only), or a range
of debug instruments (emulators and in-circuit debugging hardware).
1. Once you have built your application for debugging, select Debug Instrument > Target
Settings.
The Debug Instrument Settings window will open.
2. In this window, use the Debug Instrument Selection list box to select your debugging
hardware (emulator or other device), as shown in Figure 9.
This list box contains the list of debug instruments that support your target
microcontroller.
Figure 9. Debug instrument selection
3. Use the Target Port Selection list box to identify the port (parallel, USB, or Ethernet)
that your debug hardware is connected to, as shown in Figure 10.
To add a port that is not in the list, click on Add to open the Add Connection dialog
box. For more information about adding a connection, see Section 5.1: Selecting the
debug instrument on page 161.
4. To confirm your selection, click on Apply. Close the window by clicking on OK.
When you start your debugging session (Debug > Start Debugging), STVD will ask
you to confirm your selection and then establish the connection with your debug
instrument.