User manual

UM0036 DVP and EMU2 (HDS2) emulator features
Doc ID 7705 Rev 11 247/385
Figure 181. Hardware Test dialog box (DVP version)
The Hardware Test dialog box shows a list of different tests that can be performed. Check
the box for each test that you want to perform (they are all checked by default) and click
Apply to start the hardware test.
The hardware tests are performed one by one, and the results summarized in the dialog
boxes. For example, the hardware test for the EMU2 Emulator appears as shown in
Figure 182.
Figure 182. Hardware test underway (EMU2 emulator version)
Note: Some MCU options and memory mappings will stop the launching of a Hardware Test. To
run the hardware test, you will have to reset the MCU configuration to the default settings.
Do this by closing your debug session (Debug>Stop Debugging) and changing the MCU
selection in the MCU tab of the Project Settings window (Project>Settings). Once you have
changed the MCU selection you can restart your debug session and run the hardware test.