User manual

UM0036 DVP and EMU2 (HDS2) emulator features
Doc ID 7705 Rev 11 239/385
From this contextual menu, you can:
● Refresh: Updates the window.
● New Hardware Event: Adds a new hardware event.
● Enable/Disable Selected Hardware Event: If you select a specific hardware event,
and then right-click to obtain the contextual menu, choosing this option disables the
event. A disabled event is signaled by a gray circle in the Hardware event column.
● Enable/Disable All Hardware Events: A toggle switch to enable or disable all
hardware events.
● Remove Selected Hardware Event: If you select a specific hardware event, and then
right-click to obtain the contextual menu, choosing this option removes that event.
● Remove All Hardware Events: Erases all hardware events.
8.2.2 Adding a hardware event
You can add a hardware event from the Hardware Events window or from the Editor
window (if you want to set a hardware event on a specific symbol in your application
program).
To add a hardware event from the Hardware Events window
1. Right-click the mouse while the mouse pointer is anywhere in the Hardware Events
window.
2. Choose New Hardware Event from the contextual menu.
The Hardware event settings dialog box opens as shown in Figure 168 or Figure 169.
Figure 168. Hardware event settings window for EMU2 emulator
If you are using an EMU2 Emulator, in the Hardware event setting dialog box, choose
the trigger output that you want the signal to be sent to (either OUT1 or OUT2) and
check the Enabled box.