User manual

Simulator features UM0036
204/385 Doc ID 7705 Rev 11
signal while your application is not running, the signal is taken into account, or the
countdown for the delay begins as soon as you start running your application (Debug>Run).
Signals are reset to their defaults when the application is restarted or when the MCU is
reset.
Trigger an analog or digital signal with a delay
1. Select View>I/O Stimulation from the main menu bar.
The I/O Stimulation window opens, showing all I/O pins for your selected MCU.
2. Click on the pin name to select it.
3. Double-click in the value field corresponding to the pin that you want to simulate a
signal on.
The I/O Stimulation dialog box opens.
4. Select the signal type: Digital or Analog.
5. For a digital signal, click on the radio button for VDD (1) or GND (0).
For an analog signal, enter a value (0 - 6.5V TTL) in the Analog Value field.
6. To specify a time delay, enter a value in the Delay Time field. Time delays are
measured in CPU cycles.
7. Click on OK.
Figure 152. Define a value and delay for an input signal