User manual

Introduction UM0036
20/385 Doc ID 7705 Rev 11
ST7-DVP series emulator
– Output signals triggered by advanced breakpoints
– Trace recording and trace filtering capability (256 hardware cycles for DVP2, 512
hardware cycles for DVP3)
– Specify the address for the stack overflow point
– Data breakpoint on address read and/or write access
– Hardware test feature for troubleshooting your emulator
– In-circuit debugging and programming via ICC connection
ST7- EMU2 series emulator
– Output signals triggered by hardware events
– Trace recording and trace filtering capability (1K hardware cycles)
– Data breakpoint on address read and/or write access
– Logical analyzer controls breaks in application execution or trace recording based
on multiple conditions
– Hardware Test feature for trouble shooting your emulator
ST7-EMU3 series emulator
– Output signals triggered by advanced breakpoints
– Trace recording and trace filtering capability (256K hardware cycles)
– Instruction breakpoints on Opcode fetch
– Advanced breakpoints control breaks in application execution or trace recording
based on multiple, nested conditions
– Non-intrusive read/write of variable during emulation with Read/Write on-the-fly
– Application performance analysis with graphical display measures real execution
time of specified portions of code
– In-circuit debugging and programming via ICC add-on
STice emulation
configuration
– Advanced breakpoints with up to 4 levels of user-configured conditions
– Application profiling for execution time or number of executions at instruction,
source code or function level
– Unlimited instruction breakpoints for the entire MCU memory space
– Control of application memory accesses configurable at byte level
– Trace of 128K records with time stamp
– Data breakpoints
– Non-intrusive read/write to memory and internal registers during emulation
– CPU frequency from 250Hz up to 50MHz.
– Power supply follower managing application voltages in the range 1.65V to 5.5V
(0.8V is possible for MEB with a specific TEB)
STice
ICD configuration
– In-circuit debugging/programming via the SWIM protocol
Table 3. Advanced debugging features
Debugging configuration Features