User manual

Basic debugging features UM0036
166/385 Doc ID 7705 Rev 11
Figure 107. Specifying a new memory zone
5.2.2 On-chip peripherals
The Options tab of the MCU Configuration window, allows you to configure your target
device’s options and on-chip peripherals. All of the configurable options for your target
microcontroller are listed in the Options column. Depending on the microcontroller
selected, the configurable options and the default settings displayed in the Option column
will change.
Beside each option, a default value is displayed. To change the value for an option, double-
click in the Value field associated with the option. Then select the new value from the pull
down list.
Figure 108. On-chip peripherals
Note: For more information about the configurable options available on your target hardware
device, refer to your microcontroller datasheet.
Caution: When in-circuit debugging, if you have the wrong option settings, your microcontroller might
fail to start up. For more information, refer to Section 7.1.4: Configuring option byte settings
on page 226 under Section 7: In-circuit debugging on page 223.