User's Manual

Visteon Confidential
../ULCR Users Manual v0.9.doc Pg 13 of 13
AHU CALLING FEATURES
INCOMING CALL NOTIFICATION
Current audio source will be muted
Audible Ring Tone will be played through the vehicle speakers
Caller ID will be displayed on the AHU display
ANSWER AN INCOMING CALL
1. Press [►║OK] or [
│◄◄ ] (Seek Down) to answer the call (after receiving notification of an Incoming Call).
REJECT AN INCOMING CALL
1. Press [
►►│ ] (Seek Up) to reject the call (after receiving notification of an Incoming Call).
PLACE AN OUTGOING CALL (DIGIT DIALING)
1. Press [PHONE] to place the AHU into Phone Mode – the BT User Friendly Name of the connected phone will be displayed
2. Press [Digits: 0-9, *, #, long press of 0 for + ] to enter the number to be dialed
3. Press [►║OK] or [
│◄◄ ] (Seek Down) to dial
MUTE and UNMUTE OUTGOING (MIC) AUDIO DURING A CALL
1. Press [►║OK] to mute Mic audio after an active call has been established – MIC OFF followed by the Caller ID will be displayed.
OFF will be displayed in place of the call timer.
2. Press [►║OK] again to unmute Mic audio – MIC ON followed by the Caller ID will be displayed.
The call timer will replace OFF.
FCC Warning.
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation.