Owner`s manual

8
AUTO/OFF MODE: (Requires a thermostat)
To START: The unit will start automatically�
OPERATION: The stove will start automatically when the thermostat
calls for heat� Once the startup cycle is complete, the stove will run
at the heat level indicated on the display (adjustable)� When the
thermostat stops calling for heat, the stove will automatically decrease
the heat level to setting #1 for thirty minutes� If the thermostat calls
for heat within the thirty minutes, the stove will increase the heat level
back to the heat level indicated on the display� If the thermostat does
not call for heat within thirty minutes, the stove will begin a shutdown
cycle� The stove will restart the next time the thermostat calls for heat�
To adjust the high setting, press the heat level up/down buttons�
Figure 6: Thermostat Switch in ON/
OFF position.
ROOM AIR
FAN ON/OFF
ON/OFF
FEED RATE
TRIM
COMBUSTION
BLOWER TRIM
HEAT LEVEL
AUTO/OFF
HIGH/LOW
MANUAL
AUGER
C-11625
MODE
ROOM AIR
FAN ON/OFF
ON/OFF
FEED RATE
TRIM
COMBUSTION
BLOWER TRIM
HEAT LEVEL
AUTO/OFF
HIGH/LOW
MANUAL
AUGER
C-11625
MODE
1
2
3
4
5
6
8
7
9
Figure 5: Thermostat Switch in
HIGH/LOW position.
ROOM AIR
FAN ON/OFF
ON/OFF
FEED RATE
TRIM
COMBUSTION
BLOWER TRIM
HEAT LEVEL
AUTO/OFF
HIGH/LOW
MANUAL
AUGER
C-11625
MODE
ROOM AIR
FAN ON/OFF
ON/OFF
FEED RATE
TRIM
COMBUSTION
BLOWER TRIM
HEAT LEVEL
AUTO/OFF
HIGH/LOW
MANUAL
AUGER
C-11625
MODE
1
2
3
4
5
6
8
7
9
HIGH/LOW MODE (Requires a thermostat)
To START: Same as ‘Manual Mode’ above�
OPERATION: When operating in High/Low mode the stove will run on
one of two levels, depending on whether or not the thermostat is calling
for heat� When the thermostat is calling for heat the stove will run on
High setting (adjustable)� When the thermostat is not calling for heat,
the stove will run on Low setting (#1, not adjustable)� To adjust the
High setting press the heat level up/down buttons� The High setting
can be set to heat levels 2 through 5�
Operating Instructions
Figure 4: Thermostat Switch in
MANUAL position.
ROOM AIR
FAN ON/OFF
ON/OFF
FEED RATE
TRIM
COMBUSTION
BLOWER TRIM
HEAT LEVEL
AUTO/OFF
HIGH/LOW
MANUAL
AUGER
C-11625
MODE
ROOM AIR
FAN ON/OFF
ON/OFF
FEED RATE
TRIM
COMBUSTION
BLOWER TRIM
HEAT LEVEL
AUTO/OFF
HIGH/LOW
MANUAL
AUGER
C-11625
MODE
1
2
3
4
5
6
8
7
9
MANUAL MODE:
To START: Press the ON / OFF button� The stove will begin the startup
cycle� The mode light will be flashing� The Auger Light will flash with
each pulse of the auger� The heat level indicator will show the heat level
the unit will operate at after completing the startup cycle�
To OPERATE: When a fire has been established, the System Light will
turn solid (after approximately 10 - 15 minutes)� The room air fan will
turn on� The speed of this fan is controlled by the heat level setting�
oPeRating youR PeLLet Stove
tuRning youR PeLLet Stove off
• MANUAL and HI / LOW mode: To turn the unit OFF, simply press the ON / OFF button� This will stop
the feed of pellets� The fans will continue to operate while the stove cools down� When cool enough,
the fans will turn off�
• AUTO / OFF mode: To turn the unit OFF, turn the thermostat down or off� NOTE: The unit will run on
low for thirty minutes before it begins a shutdown cycle� To force the stove to start a shutdown, switch
the mode to MANUAL and press the On/Off button� The stove will begin a shutdown cycle�
NEVER unplug the unit while Combustion fan is operating.
This may lead to smoke escaping from the stove.
Note: The thermostat mode can be changed at any time during normal operation.