Owner`s manual

ManualsBrandsVistaflame ManualsKitchen AppliancesVF 100A

Air Supply Inlet

Gas Meter

Restriction Zone

(Termination not allowed)

Termination Cap

Opens

hot enough to cause burns if touched by children� Non-combustible shielding or guards may be required�

3� Termination must exhaust above the inlet elevation� It is recommended that at least five feet of vertical pipe be

installed outside when the appliance is vented directly through a wall, to create some natural draft to prevent the

possibility of smoke or odor during appliance shut down or power failure� This will keep exhaust from causing a

nuisance or hazard from exposing people or shrubs to high temperatures� In any case, the safest and preferred

venting method is to extend the vent through the roof vertically�

4� Distance from the bottom of the termination and grade is 12” (30 cm) minimum� This is conditional upon the

plants and nature of grade surface� The exhaust gases are hot enough to ignite grass, plants and shrubs located

in the vicinity of termination� The grade surface must not be lawn�

5� If the unit is incorrectly vented or the air to fuel mixture is out of balance, a slight discoloration of the exterior

of the house might occur� Since these factors are beyond the control of Sherwood Industries Ltd, we grant no

guarantee against such incidents�

NOTE: Venting terminals shall not be recessed into walls or siding.

Installation

vent teRmination ReQuiRementS

IT IS RECOMMENDED THAT YOUR PELLET STOVE BE INSTALLED BY AN AUTHORIZED DEALER/INSTALLER.

Figure 26: Use in conjunction with Table 1 for allowable exterior vent termination

locations.

Table 1: Use in conjunction with Figure 19 for allowable exterior vent termination locations.

Letter Minimum Clearance Description

A 24 in (61 cm) Above grass, top of plants, wood, or any other combustible materials�

B 48 in (122 cm) Beside/below any door or window that may be opened� (18” (46 cm) if outside

fresh air installed�)

C 12 in (30 cm) Above any door or window that may be opened� (9” (23 cm) if outside fresh air

installed�)

D 24 in (61 cm) To any adjacent building, fences and protruding parts of the structure�

E 24 in (61 cm) Below any eave or roof overhang

F 12 in (30 cm) To outside corner�

G 12 in (30 cm) To inside corner, combustible wall (vertical and horizontal terminations)�

H 3 ft (91 cm) within a height

of 15 ft (4�5 m) above the

meter/regulator assembly

To each side of center line extended above natural gas or propane meter/

regulator assembly or mechanical vent�

I 3 ft (91 cm) From any forced air intake of other appliance

J 12 in (30 cm) Clearance to non-mechanical air supply inlet to building, or the combustion air

inlet to any appliance�

K 24 in (61 cm) Clearance above roof line for vertical terminations�

L 7 ft (2�13 m) Clearance above paved sidewalk or paved driveway located on public property�

1� Do not terminate the

vent in any enclosed or

semi-enclosed areas such

as a carport, garage,

attic, crawlspace, narrow

walkway, closely fenced

area, under a sun deck

or porch, or any location

that can build up a

concentration of fumes

such as stairwells, covered

breezeway, etc�

2� Vent surfaces can become