Owner`s manual

16
DeciDing WheRe to Locate youR PeLLet aPPLiance
1� Do not install the stove in a bedroom or room where people sleep in�
2� Locate the stove in a large and open room that is centrally located in the house� This will optimize heat
circulation�
3� Check clearances to combustibles and for the least amount of interference to
house framing, plumbing, wiring, etc�
4� You can vent the stove with approved pipe through an exterior wall behind
the unit or pass it through the ceiling and roof� The stove can connect to an
existing masonry or metal chimney (must be lined if the chimney is over 6”
(15 cm) diameter, or over 28 inches² (180 cm²) cross sectional area)�
5� This unit must not be installed directly onto carpet� If it is to be installed on
a carpeted area a non-combustible hearth pad must be installed between the
unit and the carpet�
6� If the unit is to be installed on a solid combustible surface
(hardwood, linoleum) a non-combustible hard pad is required unless
the pedestal has been adjusted as seen in page 16�
7� This unit uses large quantities of air for combustion; outside Fresh Air
connection is strongly recommended� Fresh Air must be connected where
required by local codes�
8� Do not obtain combustion air from an attic, garage or any unventilated space�
Combustion air may be obtained from a ventilated crawlspace�
9� The power cord is 8 feet (2�43 m) long and may require a grounded extension
cord to reach the nearest electrical outlet�
Installation
theRmoStat inStaLLation
Remove jumper
wire and install
thermostat wires here.
Figure 19: Thermostat wire placement.
1� Install the wall thermostat (millivolt rated) in a location
that is not to close too the unit but will effectively heat
the desired area�
2� Connect the Thermostat or Timer using a 2 x 18 gauge
wire from the unit to the thermostat�
If the heat in the room becomes to great, the high limit
switch may turn the stove off and the switch will have to
be manually reset� To reset the high limit switch, remove
the right cabinet side� The switch is found on the air
jacket�