Owner`s manual

15
aDjuStment of PeDeStaL - fReeStanDing
The freestanding model is supplied with a pedestal
already attached to the fireplace� Once your free
standing stove has been removed form the pallet you
can adjust the pedestal base� There are three positions
for the pedestal base� The position are 2�25, 3�50, and
6�00 inches from the inside of the door opening to the
front edge of the pedestal base, the stove is packaged
in the 2�25 inch position�
1� Remove the fireplace from the pedestal� This is done
by removing the ash drawer and loosening the four
5
/16” hex head screws located inside the pedestal�
2� Once loose the stove can slid backward and lifted off
the pedestal�
3� Flip the pedestal over and remove the four
5
/16” hex
head screws which secure the pedestal base�
4� Move pedestal base to desired position and secure
using the same screws�
Figure 15: Pedestal adjustments.
2�25”
3�50”
6�00”
heaRth PaD ReQuiRementS - fReeStanDing
When installing this unit on carpet a non-combustible
hearth pad is always required, it does not matter what
position the pedestal base is in� A non-combustible
hearth pad is also required on solid combustible
materials (hardwood, linoleum) in the 2�25 and
3�50 inch positions� If the pedestal base has been
adjusted to the furthest forward position (6�00 inch)
no heath pad is required� In the 6 inch position the
pedestal base provides sufficient floor protection to
be installed on solid combustible material without a
hearth pad�
Figure 16: Pedestal 6” position no hearth pad
Hardwood
Carpet
Figure 17: Pedestal 6” position no heath pad
Hardwood
Figure 18: Pedestal 2.25” position with hearth pad