Owner`s manual

Installation of firebox backing:

• Install the side panels in place� Insert center panel, hold the panels in place

• Install the top rod by sliding it into one side panel then across into the other panel� Screw rod in

place�

• Re-install steel brick liner and screw in place�

• Replace top baffle

EXHAUST VENT (season)

The products of combustion will contain small particles of flyash� The flyash will collect in the exhaust

venting system and restrict the flow of the flue gases� Incomplete combustion, such as occurs during

startup, shutdown, or incorrect operation of the room heater will lead to some soot formation which

will collect in the exhaust venting system� The exhaust venting system should be inspected at least

once every year or after two tons of pellets to determine if cleaning is necessary� We recommend

contacting your dealer for professional cleaning� To remove dust from the vent pipe, tap lightly on the

pipe to dislodge any loose ash� Open the bottom of the “T” to dump the ash, then vacuum as much of

the ash out of the vent pipe as possible�

BLOWER MECHANISMS (season)

Unplug the stove then open the right/left side panels to access the two blowers� Vacuum all dust from

motors� Only the convection blower motor (on the right side of the stove) will require lubrication� The

convection motor has two lubrication holes on it� Use two drops of SAE 20 light oil to lubricate every six

months� Excess oil may damage the motor� The exhaust blower’s motor has sealed bearings, DO NOT

lubricate this motor�

DOOR GLASS (It is recommended that your dealer replace the glass if broken.)

The door glass is made of 5 mm thick, high temperature PYROCERAMIC� To replace the glass, unscrew

and remove the four glass retainers� Remove the glass and any broken pieces� High temperature

fiberglass tape should be used around the glass� Replace the glass, center the glass assembly in the

frame, then screw the glass retainers back to the frame� The use of substitute materials is prohibited use

only part EF-062�

POST SEASON CLEAN-UP

Once you are finished using the pellet appliance for the season, unplug the stove for added electrical

protection� It is very important that the stove be cleaned and serviced as stated above�

CLEANING PLATED SURFACES

Please clean all fingerprints off of all gold parts, with denatured alcohol on a soft cloth, before firing the

unit each time� Fingerprints, etc� can become permanently etched into the gold if not removed before

operating the pellet heater�

BRICK PANEL

The paint on the steel brick panel may peel� This is due to extreme conditions applied to the paint and is

in no way covered by warranty�

Routine Cleaning and Maintenance