Installation guide

3.2. Access from the internet
Access from the internet Once connected, the VK2-ENCODER is accessible on your local
network (LAN). To access the video encoder from the Internet you must configure your
broadband router to allow incoming data traffic to the video encoder. To do this, enable the
NAT-traversal feature, which will attempt to automatically configure the router to allow
access to the video encoder. This is enabled from Setup > System > Network > NAT.
For more information, please see NAT traversal (port mapping) for IPv4, on page 51.
3.3 Setting the administrator password
To gain access to the product, the password for the default administrator user
must be set. This is done in the “Admin Password” dialog, which is displayed
when the network camera is accessed for the setup at the first time. Enter your
admin name and password, set by the administrator.
Note: The default administrator username and password is “admin”. If the
password is lost, the Network Camera must be reset to the factory default
settings. See page 12.