User manual

61
3.8 Resetting to the factory default settings
To reset the VK2-VGAVFD to the original factory settings, go to the Setup>System> Maintenance web
page (described in “3.6.6 System > Maintenance”) or use the control button on the VK2-VGAVFD, as
described below:
• Using the Reset Button
Follow the instructions below to reset the VK2-VGAVFD to the factory default settings using the
Reset Button.
1. Switch off the VK2-VGAVFD by disconnecting the power adapter.
2. Open the lens cover.
3. Press and hold the Control Button (SW1) on the board with your finger while reconnecting
the power.
4. Keep the Control button (SW1) pressed during about 2 seconds.
5. Release the Control Button (SW1).
6. The VK2-VGAVFD resets to factory defaults and restarts after completing the factory
reset.
7. Close the lens cover.
CAUTION: When performing a Factory Reset, you will lose any settings you have saved.