User manual

4. The encoder‟s Live View page appears in your browser.
3.2. Access from the internet
Access from the internet Once connected, the VK2-540VRD is accessible on your local
network (LAN). To access the VK2-540VRD from the Internet you must configure your
broadband router to allow incoming data traffic to it. To do this, enable the NAT-traversal
feature, which will attempt to automatically configure the router to allow access to the VK2-
540VRD. This is enabled from Setup > System > Network > NAT.
For more information, please see NAT traversal (port mapping) for IPv4, on page 60.
3.3 Setting the admin password over a secure connection
To gain access to the product, the password for
the default administrator user must be set. This
is done in the “Admin Password” dialog, which is
displayed when the VK2-540VRD is accessed for
the setup at the first time. Enter your admin
name and password, set by the administrator.
Note: The default administrator username and
password is “admin”. If the password is lost, the
VK2-540VRD must be reset to the factory default
settings. See “3.9 Resetting to the factory default
settings”.