Specifications
Introduction
Alarm Output Advhmy
This system includes an alarm
output rated at 2 amps.
Throughout the manual,
wherever reference is
made to Alarm Output
Ratings, they assume a
fully charged battery is
connected, unless the UL
rating is stated. The battery
is periodically tested automati-
cally (approximately every four
hours), and if it cannot sustain a
load, a low battery message is
displayed and can be reported to
the central station.
Muftiple Consoles
(up to 4) maybe used, as long
as their total current drain is
within the alarm and auxiliary
power output limitations de-
scribed in the SPECIFICATIONS
AND ACCESSORIES section.
System
Zones Supported
Relay Outputs
Programming
Remote Consoles
Uoice Module
‘or more information,
seepage 14 and field
’26 on page 18.
Jser Codes
Communication
The VISTA-10 is a microprocessor-based state-of-the-art
security control intended for wireless as well as wired zone
applications.
Supports up to
22 zones, in the following configuration:
● 6 hard wired EOLR “basic” zones.
“ Up to 16 RF expansion zones by using an appropriate
5881 type RF receiver (up to 8 with 4281 type). Refel
to the Zone Characteristics tabulation on the next page
for detailed zone information.
Afote: The sh@e 4281/5881 type RF receiver that the
VISTA-1 O accommodates, features Spatial
Diversity (dual antennas), which virtually eliminates
the possibility of “Nulls” and “Dead Spots” within
the coverage area.
4 output relays can be added, to perform programmable
actions in response to zone activity or manual entries, by
using a No, 4204 Relay Module.
A No. 5137AD or 6139 Alpha Console is
required for programming zonea and relay
~peration, but it need not remain in the system. These
consoles have digital keypads and 2-line 32 character
alphanumeric LCDS (Liquid Crystal Displays).
Programmed options to establish specific alarm and re-
oorting features are stored in electrically erasable, non-
volatile EEROM memory. This means that the unit can be
reprogrammed many times (unlike units equipped with
PROMS) and that information which has been pro-
~rammed will not be lost during a complete loss of power.
In addition, the system can be uploaded, downloaded, or
~ontrolled via a computer and Hayes modem (see F?E.
MOTE PROGRAMMING AND CONTROL on page 32).
4fter programming, the system may use one or more
w, 4137 AD, 5137AD, 6127, 6128, 6137, 6138, or
5139 Consoles. The underlined models have fixed En-
~lish status LCDS. The others have alphanumeric displays.
Note: Nos. 4137AD, 5137AD, 6128, 6137, 6138, and
6139 are Addressable Consoles and must be set
to their non-addressable mode (device ID 31 ).
A/hen wireless is in use, the system may also be armed
md disarmed with a wireless keypad (No. 5727/5827) or
Mher 5800 RF button type transmitters (e.g., Nos. 5801,
5802, 5803, 5827BD).
4 No. 4285 Voice Module can be connected to the sys-
em. It enables Touch-tone telephones to control, and re-
:eive messages from, the system remotely. Addressable
VD
e consoles must b
e used (not4127 or 6127).
The Voice Module is not Listed for l.JL installation use.
Jp to 6 secondary user codes can be assigned by the sys-
em’s Master code.
Tele~hone: Communication capability (central station
reporting, voice module accommodation,
etc.) over existing phone lines is provided.
Radia An output for optional Long Range Radio
(7720ECP) is also provided.
-5–