Specifications

●96 INITIALIZE DOWNLOAD ID AND SUBSCRIBER ACCT. No.
FOR DOWNLOADING
(No
data entry required, loads defaults)
*97
SET ALL PROGRAM FIELDS TO DEFAULT VALUES
(No data entry required)
Press X98 or *99 if exiting programming,
or next Field No. if continuing.
ToEXIT ’98
EXITS PROGRAMMING MODE and prevents re-entry by :
PROORAMMINQ MODE
Master Code + CODE + O
(*98
or *99) ● ~ ~
EXITS PROGRAMMING MODE and abvs re-entry by:
Master Code + CODE + O
or by:
Power-up + x + #.
.
ALPHA DESCRIPTION ENTRIES
See the ALPHA FIXED DICTIONARY and CHARACTER CHART on page 29.
If using a 4285 Voice Module, selection from the group of words in boldface type is suggested.
The voice module will not provide annunciation of the other words.
Assigning
Zone Descriptors
Entering
Zone Descriptors
(in f~eld *56 or *82)
The AIDha Console used with the control can have a user-friendly Enalish
language description/location of all protection zones, keypad panic;, an~ RF
receiver supervision faults programmed into the system. Each description can be
composed of a combination of words (up to a maximum of 3) selected from a vo-
cabulary of 244 words stored in memory (see page 29). In addition, up to 5 in-
staller-defined words can be added to those already in memoty. Thus, when an
alarm or trouble occurs in a zone, an appropriate description for that zone’s loca-
tion will be displayed at the console.
Note: Alpha Descriptor entry can be done locally at the Aluha Console or re-
1.
2.
3.
motely using V-Link Downloading Sofiware. Th”e Alpha Console
procedure is described below.
The descriptor can be entered when the zone is being defined in field *56 or
it can be entered later, in field ●82.
Key [X][O][l] to begin entering the description for zone 1 (key [X][O][2] for
zone 2, [X][O][3] for zone 3, etc.). /f nothing was entered previous/y, the fol-
lowing will be displayed:
~
Note that the first letter of the alphabet appears after the zone number, and
that the zone number is automatically included with the description. /f there
already is a description for the zone, the description will appear (with no cur-
sor, since this is a display mode).
Ifitis desired to enter or change a descrip-
tion, key in [~] + Zone Number again. A flashing cursor will now appear.
One of two methods of entering the words can now be used
(assume, for example that the desired description for zone 7 is BACK DOOR):
a) Press [#] followed by the 3 digit number of the first word
from the fixed dictionary shown on page 29 (e.g., [0][1 ][3] for
BACK). Press [6] in order to save the word and proceed, or...
–27–