User manual

48
Quantum Plus installation and user manual
For SENDER MAIL ID and SENDER DOMAIN, this is best explained by an example, if the
following is input:
SENDER MAIL ID: QUANTUMPLUS
SENDER DOMAIN: NORBAIN.CO.UK
Then the receiver will receive a mail from [e-mail]
Note: This is not a valid e-mail address for replies.
SEND TEST MAIL sends a test E-mail to the addresses so allowing the installer to verify if
the setup is correct.
SMTP Mode
The SMTP function allows e-mails to be sent over a LAN
The default is SMTP Mode “OFF”.
In order to activate SMTP Mode, choose SMTP Mode either IP or Domain first.
Then, put ID, Password, IP address, and port.
Finally press “SMTP Status Check” to see whether it works.
Please see the screen shots that follow: