User manual

112
Vista QPlus H.264 V2.2 (RP03)
Quantum Plus H.264 installation and user manual
Beep Out
Alarm Out
The internal buzzer can be set to sound on
the following occurrences:
Video Loss
Alarm activation
Motion Detection
Power loss
The duration of the buzzer can be set.
The Alarm output relay can be set to activate
on the following occurrences:
Video Loss
Alarm activation
Motion Detection
Power loss
Smart – Disk test
The duration of the relay closure can be set.
If the relay follower is set to yes, each time a
camera is selected a relay out put on the rear
of the DVR will close. This can be used as the
alarm input to a switcher to allow the monitor
outputs of multiple DVR‟s to be switched to a
single monitor.
Relay control – if set to Yes then the relay can
be remotely toggled via the relay control icon
on the client software.