User manual

0150-0201C 47 Vista Columbus System Triplex

Macro: Select the desired macro number.

A form is provided in section 11 to keep track of scheduled macros.

q Main Menu → Macro → Edit Submacro

A submacro is an RS232 command string used to control a peripheral device. Submacros are

activated during macros. See the table on the previous page for information about programming a

macro to activate a submacro.

Select the submacro you wish to edit from the menu system. This menu will appear.

Edit Submacro 01

ENTER key starts Submacro edit

080 066 066 010 --- --- --- --- --- ---

[P] [B] [B] [0]

[CANCEL] [OK]

Use this menu to create the RS232 command string. Press the Enter button to Enter and Exit the

submacro edit mode. Use the Arrow Button to navigate, and change the values. Each byte value

can be set from 0 to 255.

Running A Macro

A macro is a recorded sequence of up to 32 keystrokes. To activate a

macro, press the Function button followed by the Number button of the

desired macro. While running, the macro is indicated on-screen as the letter

F and the macro number.

The user can cancel the macro at any time by pressing the Function button.

Function and

Number Buttons

Daylight Savings Time

To adjust the time one hour for daylight savings time, press the Function

button, then the Sequence button. If this function is activated during April,

one hour is added to the time. If this function is activated in October, one

hour is subtracted from the time. This function will only operate once per

time period.

Function and

Sequence Buttons

3.13 Motion Detection

Use this menu to:

• Enable motion detection on a per camera basis.

• Set motion detection as Activity detection or Intrusion Detection.

• Configure the motion detection parameters on a per camera basis.

• Activate individual zones in a scene to respond to motion

detection.

• Activate the on-screen motion detection indicator.

Setup Parameters

Setup Active Zones

Indicate Detection

Enable/Disable Detection