Use and Care Manual

8
Operation (continued)
TIMER
To set Timer for a 30-minute to 24-hour delay before the dehumidier is turned off (the dehumidier must be On):
□ Press TIMER. Timer indicator light will come on, and the display will ash. The display will show remaining time
before the dehumidier wiII turn off.
□ Press the Plus or Minus button to change the delay time, from 30 minutes to 24 hours.
To set Timer to turn on the dehumidier, with previous setting:
□ Turn off the dehumidier.
□ Press TIMER. Timer indicator light will ash. The display will show remaining time before the dehumidier will turn
on.
□ Press the Plus or Minus button to change the delay time, from 30 minutes to 24 hours.
To clear the Timer delay program:
□ Press TIMER once after it has been programmed. Display will show remaining time. While the display is showing the
remaining time, press TIMER again. Timer indicator light will turn off.
NOTE: Dehumidier can be either on or off.
To see the remaining time:
□ Press TIMER once after it has been programmed. Display will show remaining time.
NOTE: Empty the water bucket before setting the timer function. If the water bucket becomes full
during the Timer function, the Empty Bucket light goes on and dehumidication stops.
CLEAN FILTER
□ When the Clean Filter indicator light is on,remove, clean and replace the air lter. See “Cleaning the Air Filter”.
□ Press the Clean Filter button to reset the lter monitor.
NOTE: When the light is on, it will remain on for 180 hours or until you press Clean Filter button.