Use and Care Manual

15 HOMEDEPOT.COM
Please contact 1-877-527-0313 for further assistance.
Troubleshooting
Before calling for service, please try the suggestions below.
Problem Solution
Dehumidier will not operate
DANGER: ELECTRICAL SHOCK HAZARD
□ Plug into a grounded 3-prong outlet.
□ Do not remove ground prong.
□ Do not use an adapter.
□ Do not use an extension cord.
□ Failure to follow these instructions can result in death,
re, or electrical shock.
□ The dehumidier is turned off. Turn on the dehumidier.
□ The power supply cord is unplugged. Plug into a grounded
3-prong outlet. See “Pre-Installation” on page 5.
□ A household fuse has blown, or a circuit breaker has tripped.
Replace the fuse, or rest the circuit breaker. See “Electrical
Requirements” on page 4.
□ The bucket is not installed correctly. Reinstall the bucket so
that it ts all the way into the dehumidier.
□ The bucket needs to be emptied. Empty the bucket.
□ The water level oat is not in place. Remove the bucket. Make
sure the oat is snapped in place. Reinstall the bucket.
□ The dehumidier suddenly stopped operating and won’t
turn on. Conrm the power is connected, and the bucket is
in place. If the unit still doesn’t operate, call Home Depot for
Warranty service.
Dehumidier runs but does not dehumidify □ All models have an automatic de-icing function that will shut
off the compressor and allow the fan to run. When the de-
icing function senses the correct operating temperature, the
compressor will cycle back on.
□ The lter is dirty or obstructed with debris. Clean the lter.
Air coming from the dehumidier is warm □ Dehumidier will put out warm air under normal operating
conditions.
Dehumidier displays error codes □ If the dehumidier displays an error code, please contact
customer service.
No water comes out from the Quick connect hose (pump function
model)
□ The pump function is not activated. Press the Pump button to
activate the pump function. The light will turn on.
□ The drain hose is not connected correctly. Ensure the hose is
plugged to the bottom of the connector. See Pump Draining
□ The drain hose is bent or blocked. Ensure the hose is not bent
or blocked
□ The water lter has not been cleaned. Clean the water lter.