Use and Care Manual

10
Care and Cleaning
2
Gravity Draining
If you plan to run your dehumidier continuously, you can choose
direct draining by attaching a garden hose to the unit.
□ Turn off the dehumidier and unplug the power supply
cord.
□ Uncover the connector cover on the side of the unit.
□ Remove bucket.
□ Attach a garden hose to the drain hose connector on the
inside of the dehumidier. Securely attach the hose to be
sure there is no water leak.
NOTE:
□ Garden hose sold separately.
□ The drain hose inner diameter should greater than 1/2 in.
□ The connector is designed for North American garden
hoses only.
IMPORTANT: In North America the garden hose connectors
are 3/4 in. diameter straight (non-tapered) thread with a pitch
of 11.5 threads per inch (male part has an outer diameter of
1-1/16 in. (26.99 mm).
WARNING: Do not injure hands while connecting the hose.
□ Place the other end of garden hose into a oor drain. Check
to see that the hose lies at and is in the drain. Make sure
all the parts of the hose is on a lower level than the hose
connector on the dehumidier. Also, the outlet of the hose
should be at least 5.5 in. lower than the hose connector.
The hose should not be kinked or pinched.
□ Reinstall bucket.
NOTE:
□ To use the bucket without the garden hose, simply
remove the garden hose, then reinstall bucket.
□ The bucket must be installed and properly aligned for the
dehumidier to operate with or without a garden hose
connected.
1
2
Connector Level
Connector Level
More than 5.5 in
.