Installation Guide

ManualsBrandsVissani ManualsAppliances10.1 cu. ft. Top Freezer Refrigerator in White

Before use, remove all packing materials, including bottom cushions, foam pads and tapes inside of the

refrigerator; tear off the protective film on the doors and the refrigerator body.

Keep away from heat and avoid direct sunlight. Do not place the freezer in moist or watery places to

prevent rust or reduction of insulating effect.

Do not spray or wash the refrigerator; do not put the refrigerator in moist places easy to be splashed with

water so as not to affect the electrical insulation properties of the refrigerator.

The refrigerator is placed in a well-ventilated indoor place; the ground shall be flat, and sturdy (rotate left

or right to adjust the wheel for levelling if unstable).

The top space of the refrigerator shall be greater than 1.2 in, and The refrigerator should be placed against

a wall with a free distance more than 0.4 in to facilitate heat dissipation.

Spare enough space for convenient opening of the doors and drawers or statement by the distributor.

7 HOMEDEPOT.COM

Please contact 1-855-847-7264 for further assistanc

P re-Installation

PLACEMENT

1.2 in.

0.4 in.

29.5 in.

50.0 in.

27.8 in.

50.7 in.

135°

WARNING:

Information in the Instruction Manual is only for reference. The physical product may differ.

Before installation and adjusting of accessories, it shall be ensured that the refrigerator is disconnected from power.

Summary of content (6 pages)

PAGE 1
P re-Installation PLACEMENT Before use, remove all packing materials, including bottom cushions, foam pads and tapes inside of the refrigerator; tear off the protective film on the doors and the refrigerator body. Keep away from heat and avoid direct sunlight. Do not place the freezer in moist or watery places to prevent rust or reduction of insulating effect.
PAGE 2
Pre-Installation LEVELLING FEET Schematic diagram of the levelling feet. Adjusting procedures: a. Turn the feet clockwise to raise the refrigerator; b. Turn the feet counterclockwise to lower the refrigerator; c. Adjust the right and left feet based on the procedures above to a horizontal level. REVERSE THE DOOR SWING WARNING: Follow all steps when reversing the door swing.
PAGE 3
Pre-Installation 1 2 Unscrew screws of middle hinge, remove the hinge, then lift the refrigerator door up and away from your refrigerator. Save the screws to reuse. WARNING: Unplug the refrigerator from its electrical outlet. Empty all door shelves. Remove the hole cover and the right top hinge cover, then unscrew screws and remove the right top hinge. Keep the screws to reuse. Lift the freezer door up and away from your refrigerator.
PAGE 4
Pre-Installation 3 4 Unscrew screws of the bottom hinge, then remove the bottom hinge from the bottom right side of the refrigerator. Remove the sleeves from the top right of doors and hole cap from top left of doors, and assemble them on the opposite sides. Unscrew the hinge shaft from the right side of the bottom hinge and move it to the left side, then secure the bottom hinge to the bottom left side of the refrigerator, using the screws you removed previously.
PAGE 5
Pre-Installation 5 6 Install the refrigerator door vertically onto the bottom hinge. Take out the middle left hinge from the accessory bag then assemble the middle left hinge on the left side of the refrigerator. Install the freezer door vertically into the center hinge. Take out the left top hinge and left top hinge cover from accessory bag, assembly left top hinge, left top hinge cover and hole cover.
PAGE 6
Pre-Installation STARTING Before initial start, keep the refrigerator still for half an hour before connecting it to power supply. Before putting any fresh or frozen foods, the refrigerator shall have run for 2-3 hours, or for above 4 hours in summer when the ambient temperature is high. This refrigerator is tested for garage use from 38°F to 110°F, but recommended to be used from 50°F to 110°F for better cooling performance in freezer room. For colder temperature, turn the fridge setting to COLDER.