Specifications

D-300885 7
Notes for UL installations
a. The sirens connected to the sites INTERNAL or
EXTERNAL SIREN in the EXPANDER must be
suitable for burglar alarm applications. If UL fire
installation is required, all installed accessories must
comply with UL fire standards. Any external siren used,
must be UL listed and shall be rated to operate under
the voltage specified in the Specifications.
Note: The siren on the control panel PCB is non-UL
compliant.
b. A device that is connected to PGM terminal should not
exceed the current consumption defined for the 24-hour
backup period listed in the Backup Battery Options table
(see section 2.3).
c. The system shall be installed in accordance with Chapter
2 of the National Fire Alarm Code, ANSI/NFPA 70.
d. All wiring should be acceptable for class 1 systems as
defined by the National Electrical Code, ANSI/NFPA
70. No. 26 AWG or larger telecommunication line cord
shall be used.
e. The system shall be installed in accordance with CSA
C22.1 Canadian Electrical Code, Part 1.
f. A minimum spacing of 1/4 inch shall be maintained
between the telephone wiring and the low voltage wiring
(zones, bell circuit, etc). Do not route the LINE and SET
wires in the same wiring channel with other wires.
3.6 Backup Battery Insertion
Open battery compartment cover (see drawing below).
Insert one 6-battery pack or 8-battery pack and connect its
connector as shown below.
Front unit
Battery cable
Figure 3.3 - Battery Insertion
3.7 Optional GSM Module Mounting
Note: The GSM module can be used with an internal or
external antenna.
Plug in the GSM Module and fasten it with the screw:
GSM
Front
unit
Figure 3.4 - Optional GSM Module Mounting
Insert the SIM card into the GSM module:
Internal
GSM
antenna
Internal GSM
antenna cable
External GSM
antenna cable
GSM antenna (internal /
external) connector
1
Slide top
cover
Lock cover
to close
6
SIM card insertion
IMPORTANT
1.Before inserting SIM
card, deactivate its
PIN code (by using a
cellular telephone).
2.Do not insert or
remove SIM card
when the control
panel is powered by
AC power or battery.
4
Slide SIM
card into
cover
5
Rotate cover
to close
2
Open
cover
Align SIM
card in cover
(note cover
orientation)
3
Figure 3.5 - SIM Card insertion
For internal antenna only: Remove the paper strip from
the antenna sticker and stick the antenna on the control
panel. Connect the antenna to the control panel GSM
antenna connector