User guide

USER SETTINGS
28 DE5468U
U02: 1 2 3 4
Enter
partition
numbers (eg.
for partition
2&4 enter 24)
Continue the same way up to Code 8 and press
to return to SET USER CODES menu.
You may now select any other item on the USER
SETTINGS menu or quit programming by clicking
.
When <OK> TO EXIT is displayed - click
.
Enrolling Keyfob Transmitters
Eight system users carry keyfob transmitters to
exercise better, quicker and safer system functions
control. Your control panel must recognize the
unique identification code (ID) of each such keyfob to
respond to commands transmitted by them.
Before anything else, gather up all keyfob units you
intend to enroll, and make sure they all have
batteries installed. Keyfob transmitter enrolling
involves the following steps:
A. Having entered your Master User Code
successfully
(see above - Entering the User Settings Menu),
Click the
button (repeatedly, if
necessary) until the display will read:
ENROLL KEYFOB
B. Click . The display will read:
KEYFOB No: _
C. Suppose that the Keyfob you are about to enroll is to be
designated as Keyfob No. 5. Assuming that memory
location No. 5 is free - no keyfob has yet been enrolled
to it - click the <5> key. The display will change to:
KEYFOB No: 5
The clear space at the far right tells you that the
memory location is free.
D. Click
. The display will prompt you to
initiate a transmission from the chosen keyfob:
TRANSMIT NOW
E. Initiate a transmission from the chosen keyfob by
pressing any one of its pushbuttons. In response,
the “Happy Tune” (- - - –––) will sound. For
disabled partitioning mode, the display will be:
KEYFOB No: 5
Proceed to step "J" below.
For enabled partitioning mode, the display will be:
F05: PARTITION
F. Click . The display will be:
PARTITION 1
G. Select the next partition by pressing
.
The display will be:
PARTITION 2
H. Click . The display will be:
PARTITION 2
I. Click . The display will be:
KEYFOB No: 5
A dark box will appear at the far right, indicating
that the chosen Keyfob has been enrolled as
Keyfob No. 5.
J. From this point on, you may continue in several
different directions:
• If you wish to enroll another keyfob, select
the desired number by:
- Clicking
to go up (678.....)
- Clicking
to go down (432.....)
- Clicking
 <keyfob #>.
• To return to the main menu, click
. This
will bring back the display:
<OK> TO EXIT
You may now review and select any other mode on
the User menu (by clicking
or ).
Deleting Keyfob
Occupied keyfob memory locations must be cleared
(enrolled ID must be deleted) before enrolling a new
ID. To delete an existing ID, proceed as follows:
A. Select the desired memory location, as described in
the previous paragraph, steps A-C. If, for example,
you selected keyfob No. 5, the display will read:
Keyfob No. 5
B. Click . The display will change to:
<OFF> to delete
C. Click . The display will change to:
Keyfob No. 5
Note that the dark box at the far right has
disappeared. It is now possible to enroll a new ID. It
is also possible to leave the cleared keyfob location
free and simply exit to the main menu.
Enrolling Proximity Tags
Note for PowerMax Pro with partition feature:
Each proximity tag assigned to a partition will
function as determined in "Setting the User Codes".
Therefore, each proximity tag must be assigned a
relevant user code. For example, proximity tag 3 is
assigned to user code 3.
Up to 8 proximity tags can be enrolled to the
PowerMax PRO.